IAE Academy

FOR CORE AND IT JOBS · 7 CHAPTERS

VLSI Design

For ECE students. Short chapters, in reading order: cmos logic, fabrication, layout, timing, hdl and the design flow from rtl to silicon. Each one explains its ideas from first principles, with worked examples and questions to check yourself.

The chapters, in order

  1. CHAPTER 1

    The MOSFET as a switch and the CMOS inverter

    This chapter treats the MOSFET as a voltage-controlled switch and builds the CMOS inverter from it.

    Builds on the GATE topics: MOS devices (Electronic Devices) · Logic families (Digital Electronics)

  2. CHAPTER 2

    Static CMOS logic gates

    This chapter shows how to turn a Boolean expression into a static CMOS gate, how to size its transistors so rise and fall take equally long, and how transmission gates and pass transistors pass signals.

    Read first: Chapter 1, Switch and inverter

    Builds on the GATE topics: Logic families (Digital Electronics) · Combinational (Digital Electronics)

  3. CHAPTER 3

    Delay, power and scaling

    A gate switches by charging or discharging a capacitance through a resistance.

    Read first: Chapter 2, Static CMOS gates

    Builds on the GATE topics: Logic families (Digital Electronics)

  4. CHAPTER 4

    Latches, flip-flops and timing

    This chapter builds a stored bit from two inverters, then a latch and an edge-triggered flip-flop, and checks a register-to-register path for setup and hold.

    Read first: Chapter 3, Delay, power, scaling

    Builds on the GATE topics: Sequential (Digital Electronics)

  5. CHAPTER 5

    Fabrication and layout

    This chapter follows a CMOS chip from bare wafer to wired transistors, shows how a layout turns into W and L, and explains the wire resistance, wire capacitance and latch-up that the layout decides.

    Read first: Chapter 1, Switch and inverter

  6. CHAPTER 6

    Describing hardware with Verilog

    Verilog describes circuits, not programs: every block runs at once, like the hardware it names.

    Read first: Chapter 4, Latches and timing

    Builds on the GATE topics: Sequential (Digital Electronics)

  7. CHAPTER 7

    The chip design flow, from RTL to silicon

    This chapter follows a chip from a written specification to the layout sent for manufacture.

    Read first: Chapter 6, Verilog for hardware, Chapter 5, Fabrication and layout

Who hires

What companies publish for students, by department: Core jobs for ECE

All subjects for core and IT jobs