IAE Academy

FIRST YEAR · PHYSICS · CHAPTER 2 OF 7

Waves: travelling, standing and moving sources

This chapter builds the wave equation from a stretched string, solves it for travelling and standing waves, and derives beats and the Doppler shift for sound. An engineer needs it because cables, antennas, resonators and sound and radio links are described with these ideas.

Updated 30 Oct 2026

What you will be able to do

You will derive the wave equation and the speed from Newton's second law. You will read , and off a travelling wave and find the modes of a fixed string. You will derive the beat frequency and the Doppler shift for a moving source and a moving observer, and use them with the signs right.

Before you start

  1. Chapter 1, Oscillations: simple harmonic, damped and forced

  2. Newton's second law,

  3. Partial derivatives (treating the other variable as constant)

  4. Small-angle approximation and

  5. The sum-to-product identity for

  6. Relative velocity of two bodies moving along one line

The wave equation and travelling waves

A stretched string has no restoring force of its own. Tension supplies it: a bent piece of string is pulled back toward straight by the tension at its two ends. Take a short piece between and , with the string's weight neglected and every slope small. Horizontally the pulls are at both ends, in opposite directions, so they cancel and the piece moves only up and down. Newton's second law for that vertical motion links how fast the displacement changes in time to how sharply the string bends in space.

WAVE EQUATION OF A STRING

Holds for small slopes, with the string's weight neglected. The piece has mass . The vertical pull at each end is : at the right end and at the left, each end pulled away from the piece. The net vertical force is times the change in slope across the piece. Over a short that change is the rate of change of slope times : . Set and divide by . is displacement (m), position along the string (m), time (s), tension (N), mass per length (kg/m), speed (m/s), the angle of the string to the axis.

TRAVELLING SINE WAVE

Holds for the wave equation above. is the amplitude (m). is the wavelength, the distance between neighbouring crests (m), and the wave number (rad/m). is the frequency, oscillations per second at one point (Hz), and (rad/s). Substitute: and , so the wave equation needs . The phase is the argument . A crest keeps its phase, so and : the wave moves in at . In electromagnetics the of a guided wave is written , the phase constant.

The wave equation is linear: if and both satisfy it, so does , because the derivative of a sum is the sum of the derivatives. This is superposition. Within the small-slope limit, two waves on one string add point by point. Standing waves and beats both come from adding two sines.

WATCH OUT FOR

The wave speed is not the speed of a bit of string. The test: depends only on and , while the string's own speed changes with time and with .

Standing waves on a string

Send a wave along a string toward a fixed end. The end cannot move, so the reflected wave must cancel the incoming one there at every instant: it comes back upside down, with the same amplitude and frequency. The string then carries two equal waves going opposite ways, and they add. The sum does not travel. Each point oscillates in simple harmonic motion at , with its own amplitude.

STANDING WAVE FROM TWO OPPOSITE WAVES

Holds for two waves of equal amplitude and frequency. Put the fixed end at . The incoming wave travels in toward it; the reflection travels in . At they are and , which cancel. Use with , : , , and . The factor is the amplitude at each point; is the common time dependence. Nodes (zero amplitude) are at , , so neighbours are apart. Antinodes (amplitude ) lie midway, at .

MODES OF A STRING FIXED AT BOTH ENDS

Holds for fixed ends and the same for every mode. The ends and must be nodes. is already a node in . needs , which gives . Then gives ; is the lowest mode. is the string length (m), the number of half-wavelengths on the string.

WORKED EXAMPLE

A string of length m, tension N and mass per length kg/m is fixed at both ends. Find the speed of a wave on it, the lowest frequency, and the frequency of the third mode.

Solution
  1. Speed: m/s. This is the speed of every travelling wave on this string.

  2. Lowest mode: it has , so one half-wavelength fits and m. Then Hz.

  3. Third mode: , so Hz. Check: here , so m, and Hz agrees.

Answer: m/s, Hz, Hz.

WATCH OUT FOR

A standing wave is not a wave that has stopped. The test: between two neighbouring nodes every point reaches its maximum at the same instant, with no phase delay along . A travelling wave has a delay of .

Beats and the Doppler effect

Two waves of nearly equal frequency drift in and out of step. In step, the sum is loud; out of step, it is faint. That slow swell is a beat. The Doppler effect is a different change. Sound travels through still air at a speed set by the air, not by the motion of the source. Call each crest a wavefront. When source or observer moves, the number of wavefronts reaching the observer each second changes.

BEAT FREQUENCY

Holds for equal amplitudes and , measured at one point. Use the same sum-to-product identity. The sine factor oscillates at the average frequency. The cosine factor is a slow envelope, and the loudness follows , which peaks every of its argument, that is every seconds. So loud pulses come times per second. are angular frequencies (rad/s), frequencies (Hz), time (s).

MOVING SOURCE: SHORTENED WAVELENGTH

Holds in still air for motion along the line joining source and observer, with ; when the source moves toward the observer, when it moves away. In one source period a front travels through the air, while the source covers toward the observer and then emits the next front. So successive fronts reaching the observer are apart. is the speed of sound in air (m/s), the source speed (m/s), the source frequency (Hz), the spacing of fronts (m).

DOPPLER SHIFT, MOVING SOURCE AND OBSERVER

Holds under the same conditions, with ; when the observer moves toward the source, when it moves away. The observer's motion does not change , the spacing in the air. The fronts pass the observer at the relative speed , so fronts pass each second. That is the frequency heard, (Hz).

WORKED EXAMPLE

A siren of frequency 700 Hz moves at 20 m/s toward an observer, who moves away from it at 10 m/s along the same line. Sound speed is 340 m/s. Find the frequency heard.

Solution
  1. The source moves toward the observer, so m/s. The observer moves away from the source, so m/s.

  2. The numerator is the speed of the fronts relative to the observer: m/s.

  3. The denominator is m/s, which fixes the spacing m: the approaching source squeezes the fronts.

  4. Then Hz. The distance between them shrinks at m/s, so is the right direction.

Answer: About 722 Hz.

WATCH OUT FOR

Signs decide the answer. The test: along the line, if the distance between source and observer is shrinking, must exceed ; if it is growing, must be lower. Check this before trusting a number.

Check yourself

CHECK YOURSELF 1

A wave on a string is , with and in m and in s. Its direction of travel and speed are

  1. (A)

    at 150 m/s

  2. (B)

    at 150 m/s

  3. (C)

    at 300 m/s

  4. (D)

    at 600 m/s

Answer and solution

Answer: (A)

  1. Compare with : rad/m and rad/s.

  2. m/s. Check: m, Hz, m/s.

  3. The minus sign between and means the wave travels in : A.

CHECK YOURSELF 2

A string of length 0.60 m is fixed at both ends. Waves travel on it at 120 m/s. Find the frequency, in Hz, of its second mode ().

Answer and solution

Answer: (accepted range )

  1. .

  2. Hz.

CHECK YOURSELF 3One or more options are correct

A string carries the standing wave . Which statements are true?

  1. (A)

    The points and are nodes

  2. (B)

    Adjacent nodes are apart

  3. (C)

    Every point of the string oscillates with the same amplitude

  4. (D)

    All points between two adjacent nodes reach their maximum displacement at the same instant

Answer and solution

Answer: (A), (B), (D)

  1. Nodes need , so : A is true.

  2. Neighbouring nodes differ by , so : B is true.

  3. The amplitude varies with : C is false.

  4. The time factor is common to all points, and keeps one sign between adjacent nodes: D is true.

CHECK YOURSELF 4

At one point, two sound waves of frequencies 250 Hz and 256 Hz and equal amplitudes arrive together. How many loud pulses are heard in 2 s?

Answer and solution

Answer: (accepted range )

  1. per second.

  2. In 2 s: pulses.

Used in these GATE topics